Fiat 2016 500L Uconnect 6.5, Руководство пользователя

Страница: 97 / 164

Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995 . These Ga-
rage Door Openers can be identified by the “LEARN” or “TRAIN” button located where
the hanging antenna is attached to the Garage Door Opener
.
It is NOT the button that
is normally used to open and close the door . The name and color of the button may
vary by manufacturer .
1
.
Place the ignition switch into the ON/RUN position
.
2 . Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink indicator light in view
.
3
.
Push and hold the HomeLink button you want to program while you push and hold
the hand-held transmitter button
.
4 . Continue to hold both buttons and observe the indicator light . The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter
.
Release both buttons after the indicator light changes
from slow to rapid .
5 . At the garage door opener motor (in the garage), locate the “LEARN” or “TRAIN-
ING” button
.
This can usually be found where the hanging antenna wire is attached to
the garage door opener motor
.
Firmly push and release the “LEARN” or “TRAINING”
button .
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pushed
.
6 . Return to the vehicle and push the programmed HomeLink button twice (holding the
button for two seconds each time)
.
If the device is plugged in and activates, program-
ming is complete
.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to com-
plete the training
.
7 . To program the remaining two HomeLink buttons, repeat each step for each remain-
ing button
. DO NOT erase the channels .
ELECTRONICS
95