WARNING!
This vehicle does not have a center seating position
.
Do not use the center lower
LATCH anchorages to install a child seat in the center of the back seat
.
Installing The Child Restraint Using The LATCH Lower Anchors
NOTE:
Never
“share” a LATCH anchorage with two or more child restraints
.
1
.
Loosen the adjusters on the lower straps and on the tether strap of the child seat so
that you can more easily attach the hooks or connectors to the vehicle anchorages
.
2
.
Attach the lower hooks or connectors of the child restraint to the lower anchorages
in the selected seating position
.
3
.
If the child restraint has a tether strap, connect it to the top tether anchorage
.
See below for directions to attach a tether anchor
.
4
.
Tighten all of the straps as you push the child restraint rearward and downward into
the seat
.
Remove slack in the straps according to the child restraint manufacturer’s
instructions
.
5
.
Test that the child restraint is installed tightly by pulling back and forth on the child seat
at the belt path
.
It should not move more than 1 inch (25
.
4 mm) in any direction
.
Installing The Child Restraint Using The Vehicle Seat Belts
The seat belt in the passenger seating position are equipped with a Switchable Automatic
Locking Retractor (ALR) that is designed to keep the lap portion of the seat belt tight
around the child restraint
.
Any seat belt system will loosen with time, so check the belt
occasionally, and pull it tight if necessary
.
Always use the tether anchor when using the seat belt to install a forward facing child
restraint, up to the recommended weight limit of the child restraint
.
To Install A Child Seat Using An ALR:
1
.
Pull enough of the seat belt webbing from the retractor to pass it through the belt
path of the child restraint
.
Do not twist the belt webbing in the belt path
.
2
.
Slide the latch plate into the buckle until you hear a “click
.
”
3
.
Pull on the webbing to make the lap portion tight against the child seat
.
4
.
To lock the seat belt, pull down on the shoulder part of the belt until you have pulled
all the seat belt webbing out of the retractor
.
Then, allow the webbing to retract back
into the retractor
.
As the webbing retracts, you will hear a clicking sound
.
This means
the seat belt is now in the Automatic Locking mode
.
GETTING STARTED
25
Содержание 2014 500e
Страница 1: ...2 014 USER GUIDE ...
Страница 75: ...UNDERHOOD COMPARTMENT MAINTAINING YOUR VEHICLE 73 ...
Страница 90: ...NOTES 88 ...