data: 13/01/16
File: P2XT_smd_ing.doc
pag 7 di 10
•
Dimensions upper limit
0
0
0
0
As for the previous constant, the positioner prevents the entry of dimensions exceeding the value set in this
constant. Set a value upper then the maximum value of positioning dimensions
•
Display mode
%
%
%
%
Setting this function gives the possibility to convert the quota visualized on the display in a quota expressed in
inch fraction or degrees. Keeping pressed the key
PGM
for abt. 3 seconds is possible proceed to a type of
visualization to an other.
The constant
%
defines the type of conversion of the quota, using keys and
select the
visualization needed according to the following table:
%
DISPLAY FUNCTION
%#
Disabled
%
From tenth of mm to thousandths of an inch
%
From tenth of mm to hundredths of an inch
From mm to hundredths of an inch
%
From mm to tenths of an inch
From cm to hundredths of an inch
%
From dm to inches
.%
Sexagesimal degrees with display in degrees and prime numbers
..
Sexagesimal degrees with display in degrees
•
Baud rate for serial output
#0%
#0%
#0%
#0%
Not used in this version, don’t change (or set to)
%)#
%)#
%)#
%)#
.
MANUAL WORKING MODE
In manual working mode it is possible to displace the positioned axis by using the keyboard: enter
programming mode and go to menu
+
+
+
+
, press
RESET/ENTER
and the display will show the current
dimension; the auxiliary display will show “
” which indicates the manual working mode.
The key causes a fast forward displacement of the positioned axis.
The key
causes a fast backward displacement of the positioned axis.
N.B. emergency input must be closed.
Press
PGM
to exit manual working mode
.
