12
CAUTION!
Failure to obey the following procedures may result in personal injury.
•
To avoid electrical shock during the wiring harness installation, remove the
ground cable from the battery of your prime mover.
6.
Remove the ground cable from the negative (-) post of your prime mover's battery.
7.
Remove the nut from the
POSITIVE
(+) cable clamp on the battery and slide the
RED
wire ring
terminal from the wiring harness cable over the positive (+) cable clamp bolt. Secure the ring
terminal with the nut.
8.
Remove the nut from the
NEGATIVE
(-) cable clamp on the ground cable and slide the
BLACK
wire ring terminal from the wiring harness cable over the negative (-) cable clamp bolt.
9.
Reinstall the ground cable on the negative post of the battery and secure the ring terminal and
the ground cable with the nut removed in the previous step.
10.
Secure the wiring harness cable from the battery to the control box with your nylon cable ties.
11.
Feed the wiring harness cable:
a) back to the left-rear area of your prime mover,
b) past the loader arm's rear hinge point by following the hydraulic hoses where possible, and
c) down the loader arm following the hydraulic lines.
12.
Allow sufficient slack in the cable at the hinge point to provide for a full range of motion of the
loader arms. Use your nylon cable ties to secure the cable to the loader frame below the hinge
point and back to the control box.
HYDRAULIC SNOW BLOWER HYDRAULIC CONNECTION
READ AND UNDERSTAND ALL SAFETY STATEMENTS
Read all safety decals and safety statements in all manuals before beginning any Snow
Blower hydraulic connection. Know and obey all OSHA regulations, local laws, and other
professional guidelines for your operation. Know and follow good work practices when
assembling, maintaining, repairing, mounting, removing, or operating this equipment.
1.
Disconnect the hydraulic hose quick couplers from one another and attach the quick couplers to
your prime mover as per the instructions in your prime mover's operator's manual.
(Also see Hydraulic Hose Connections in the SERVICE section.)
2.
Carefully raise the loader and cycle the tilt cylinders to check hose clearances and to check for
any interference. Operate the chute and deflector on this product to make the same checks.
3.
Cycle the hydraulic cylinder(s) on this product several times from fully retracted to fully extended
until all air has been completely removed from the cylinder(s).
WARNING!
Do not lock the auxiliary hydraulics of your prime mover in the "ON" position.
Failure to obey this warning could result in death or serious injury.
INSTALLATION & SET-UP
