11
INSTALLATION & SET-UP
WARNING! READ MANUAL PRIOR TO INSTALLATION
Improper installation, operation, or maintenance of this equipment could result in
serious injury or death. Operators and maintenance personnel should read this
manual, as well as all manuals related to this equipment and the prime mover
thoroughly before beginning installation, operation, or maintenance.
FOLLOW ALL
SAFETY INSTRUCTIONS IN THIS MANUAL AND THE PRIME MOVER'S MANUAL(S).
1.
Place this product on a firm, level surface that is large enough to safely accommodate this
product, your prime mover and all workers involved in the mounting process.
2.
Refer to the operator’s manual(s) for your prime mover, loader, and quick-attach and follow the
mounting instructions contained therein.
3.
Carefully raise the loader and cycle the tilt cylinders to check clearances and to verify that all
mounting procedures have been successfully completed.
NOTICE!
Lubricate all grease fittings before connecting this product to your prime
mover's hydraulic system. Refer to HYDRAULIC SNOW BLOWER
MAINTENANCE and follow the instructions
WIRING HARNESS INSTALLATION
MATERIALS NEEDED: Nylon cable ties
1.
Park your prime mover on a level surface with this product properly attached.
2.
Place your prime mover's transmission in "Park" and engage the parking brake.
3.
Lower this product onto the level surface.
4.
Shut off your prime movers engine, remove the starter key, wait for all moving parts to come to
a stop, and relieve all pressure in the hydraulic lines.
5.
Attach the control box to the left side screen of your prime mover's roll-over protective structure
(ROPS). Use the magnet on back of the control box to secure the control box so that the box is
flat against the screen, the toggle switches are on the top, and the wiring harness cables are
on the bottom.
WARNING!
Failure to obey the following procedures could result in death or serious injury.
•
Before doing any work on your prime mover's battery, read and understand
all prime mover instructions and safety signs for your prime mover's electrical
system. Pay special attention to hazard avoidance and remedial action related
to explosive gas and acid.
