Fetco TBS-21H, Руководство пользователя

Страница: 8 / 10

8
Temperature (center dial)
The brew water temperature is adjustable from 190
°
F to 205
°
F and is factory set at 205
°
F. The adjustment is
made on the center dial of the control board. Adjustment should only be necessary at high altitudes to prevent
boiling. Check the temperature by holding a thermometer in the stream of water flowing out of the hot water
faucet with the red handle.
Brew Temperature Protection
When this feature is enabled, a brew cycle cannot begin unless the water is at the proper
temperature. If a brew cycle is started without the ready light on, no water will be dispensed and
the brew light will begin flashing. Once the water heats to the proper temperature, the brew cycle
will begin normally.
The brewer is factory set with this feature enabled. To disable it, locate the yellow wire near the
lower right side of the control board. Move the wire from the terminal labeled START 1 to the
terminal labeled START 2.
Jumper Settings
The control board is used on a variety of different brewer models. In order to function properly
in the TBS-21H, Jumper #1 must be in the closed position, as shown below:
Jumper 1 in closed position.
Correct Configuration
Jumper 1 in open position.
Incorrect Configuration
Jumper # 2 & 3 are not used for the TBS-21H.
Green Tea Faucet (optional)
The green tea faucet draws water from a separate water tank, which is controlled by a separate thermostat. The
temperature of this water is factory set at 175
°
F. Check the temperature by holding a thermometer in the
stream of water flowing out of the green tea faucet.
The green tea thermostat is located in the back of the unit, next to the main control board. Turn the adjustment
stem slightly clockwise to increase the temperature, and counter-clockwise to decrease the temperature.