
5
On initial startup, from dry tank conditions, the green "READY" will flash 3 minutes after turning unit on, indicating
a fault (low water level). Turn the power switch off and back on to reset this. Repeat one additional time if
necessary
11. Brew one dispenser (water only) to confirm proper fill levels.
•
The brewer is factory set to deliver a total of 3.0 gallons to the dispenser.
•
Tea leaves retain water after brewing, therefore your brew level will be reduced proportionally to the
amount of tea used.
•
Review the entire operating procedures with whoever will be using the brewer. Pay particular
attention to the following areas.
•
Don't remove the brew basket until it has stopped dripping.
•
Don't remove the spray plate until it has cooled from the brewing operation. It may still be hot, and
hot brew water may be retained behind it.
•
Make sure the dispenser is empty before brewing into it.
•
Show the location and operation of the water shut off valve as well as the circuit breaker for the
brewer.
•
Never unplug the tea brewer (or any high wattage equipment) while it is operating. Push the power
switch to the off position first. The resulting electrical pulse may cause a burn or shock hazard, or
damage the computer operating circuits on the control board.
•
Steam from the tank will form condensation in the vent tube. This condensation will drip into and then
out of the brew basket. Up to 1/4 cup discharging overnight is possible. Place an appropriate
container under the brew basket when not in use.
The brewer will be ready for operation as soon as the ready light comes on to signify that the water tank is up to
temperature.
Depending on the cost of electricity in your area, very little savings may be had by turning the brewer off between
shifts. The water tank is well insulated and may actually use less electricity to keep the tank hot, than re-heating
the tank from a cold condition. Leaving the brewer in the on position will also avoid delays at the beginning of
shifts for the brewer to reach operating temperature.
Содержание TBS-21H
Страница 10: ...Drawings Drawings Drawings Drawings 10...