Festool MX 1200 E EF, Инструкция по эксплуатации

Страница: 8 / 36

8
Technical data
Power 1200 W
Speed range 360-670 min
-1
Electronical speed preselection •
Tool adapter M14x2/ErgoFix
Stirrer - max 5.5" (140 mm)
Collar - 2.3" (57 mm)
Weight 4.5 kg (9.9 lbs)
Safety level / II
Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Wear protective goggles
Wear ear protection
Wear a dust mask
Disconnect from power supply
Do not dispose of as domestic waste.

Advice or tip
V Volts
A Amperes
Hz Hertz
W Watt
~
Alternating current
n
0
No load speed
Class II Construction
min
-1
Revolutions per minute
" inch
lbs pound
Ø Diameter
- Only use the tool until the stirring rod diameter
that is specifi ed in the technical specifi cations has
been reached.
- Load the machine in such a way that the speed
does not decrease too much or the machine is
forced to stop.
- Always guide the fl exible power cable from the
tool to the rear. Never pull hard on the fl exible
power cable and never set it on or guide it over
any sharp edges.
- Only work in a safe and stable position.
- Take into account that there will be a reactionary
torsional momentum.
- Do not mix any solvents or solventcontaining sub-
stances with a fl ash point of below 21 °C.
- Start up and run down the maschine un the mixing
container only.
- Do not reach into the mixing container with your
hands or insert any other objects into while mixing
is in progress.
- We recommend that you wear work gloves and
protective goggles when using the mixer. Regula-
tion require that you wear close-fi tting clothing.
Health hazard by dust
Various dust created by power sand-
ing, sawing, grinding, drilling and other construction
activities contains chemicals known (to the State of
California) to cause cancer, birth defects or other
reproductive harm. Some examples of these chemi-
cals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products,
• Arsenic and chromium from chemically-treated
lumber.
The risk from these exposures varies, depending
on how often you do this type of work.
To reduce your exposure to these chemi-
cals work in a well ventilated area and
use approved safety equipment, such as
dust masks that are specially designed
to fi lter out microscopic particles. Wash
hands after handling.
T
O REDUCE THE RISK OF IN-
JURY, USER MUST READ INSTRUCTION MANUAL.