Festool DTS 400 REQ, Оригинальное руководство по эксплуатации

Страница: 16 / 20

16
DTS 400 REQ, RTS 400 REQ
If the StickFix coating on the sanding pad has
worn out, the entire sanding pad can be replaced:
X
Undo the four screws.
X
Remove the sanding pad by pulling it downwards.
X
Attach the new sanding pad.
X
Use four screws to tighten it by hand (2.5 Nm).
7.3 Attaching sanding accessories using
StickFix [3a]
The suitable StickFix sandpaper and StickFix
sanding cloth can be attached quickly and simply
to the StickFix sanding pad.
X
Affix the self-adhesive sanding accessory to the
sanding pad.
7.4 Dust extraction
WARNING
Dust hazard
X
Dust can be hazardous to health. Always work
with a dust extractor.
X
Always read applicable national regulations
before extracting hazardous dust.
Integral dust extractor with long-life dust bag
As standard, the sanders are equipped with
an integral dust extractor. The sanding dust is
extracted through extraction openings in the
sanding pad and is collected in the dust bag.
Installing the dust bag [4]
X
Slide the dust bag adapter onto the extractor
connection piece.
X
Slide the dust bag onto the adapter until it clicks
into place.
If the suction power is decreasing, empty
the dust bag.
X
Press the dust bag onto the actuating elements.
X
Remove the dust bag by moving it towards the
rear.
X
Open the flap on the dust bag.
X
Empty the dust bag and dispose of the waste.
Dust extraction with Festool’s mobile dust ex-
tractor
To prevent having to frequently empty the dust
bag when carrying out sanding work for a long
period of time, you can connect Festool’s mobile
dust extractor (with an extraction hose diameter
of 27 mm) to the extractor connection piece [1-4] .
Recommendation : Use an antistatic suction hose.
This helps reduce the electric charge.
7.5 Edge protector [5]
The edge protector [1-6] prevents the sanding
pad circumference from coming into contact
with a surface (e.g. when sanding along a wall
or a window), thus preventing back-kick of the
machine, or machine damage.
8 Working with the machine
WARNING
Risk of injury
X
Always secure the workpiece in such a manner
that it cannot move while being machined.
Observe the following instructions:
– Do not overload the machine by pressing with
excessive force! The best sanding results are
achieved with moderate application pressure.
The sanding capacity and quality are mainly
dependent on the selection of the correct
abrasive.
– Work in corners and on edges tends to subject
the tip to increased stress and results in
increased heat development. In such cases,
work with reduced contact pressure.
– Hold the machine with one hand on the handle
[1-9] .
For sanding, we recommend the following settings
for the adjusting wheel
[1-3] :
Adjusting
wheel
setting
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered
surface prior to paintwork
– Intermediate sanding of paintwork
on surfaces
5 - 6
– Sanding thinly applied undercoat
– Sanding wood with sanding cloth
– Edge breaking on wooden parts
– Smoothing primed wooden
surfaces
4 - 5