Festool CS 70 ST, Руководство по сборке

Страница: 9 / 40

9
5.2 Adjusting the parallelism
A separate adjustment is necessary at the front
and rear supports.
• Release handle
[3-1]
.
• Release counternut
[3-8]
.
• Adjust parallelism of both tables with adjusting
screw
[3-2]
.
• Re-tighten counternut
[3-8]
and handle
[3-1]
.
6 Adjusting the parallelism of sliding table
guide and saw blade
6.1 Checking the parallelism
• Fit angle fence on sliding table.
• Set stop guide so that the front edge of the stop
is exactly fl ush with the outer table edge of the
PRECISIO. When the sliding table is moved the
edges must be equidistant throughout the entire
range of motion.
6.2 Adjusting the parallelism
The parallelism is adjusted with the screw [3-5]
on the fi tting angle on the rear of the table.
• Loosen handle
[3-1] .
• Loosen locking bolt [3-7]
• Loosen counternut
[3-6]
.
• Adjust parallelism with screw
[3-5]
.
• Check by moving the sliding table - same dis-
tance to base table at all points!
• Re-tighten locking bolt
[3-7]
, counternut
[3-6]
and handle
[3-1]
.
7 Adjusting the roller guide
7.1 Checking the guide play
The play between the guide rod and guide rollers
is usually adjusted in the works. Nevertheless, we
recommend that the guide play at both rollers be
checked as follows:
• Push on sliding table from above. When the
sliding table is moved the outer ring of the bot-
tom ball bearing also rotates if the guide play is
correctly adjusted.
7.2 Adjusting the guide play
• Loosen the locking nut
[6-1]
with the size 15
open-end spanner
[1-2]
.
• Adjust the position of the bearing via the cam
plate [6-2] using a size 5 Allen key [1-4] .
• Re-tighten nut [6-1] following correction of the
guide play.
8 Fitting the legs [Fig. 4]
• Release handle
[4-2]
.
• Place legs [4-5] vertically on the fl oor.
• Tighten handle [4-2].
9 Extra clamp for stop guide [Fig. 4]
• Insert extra clamp
[4-4]
from rear into one of
the three table grooves.
• Pivot clamping piece
[4-3]
into groove on rear
of stop and tighten with rotary knob [4-1] .
10 Dismantling the sliding table unit
The complete sliding table can be dismantled in
a trice and quickly be re-fi tted with no adjust-
ments.
• Fold away legs
[4-5] .
• Lock sliding table with rotary knob [6-5] .
• Release handles [3-1] and remove from frame
with bolt head [5-2] .
• Remove complete unit.
Re-assemble in reverse order with no adjust-
ments.