Festo MPAC-VI, Руководство пользователя

Страница: 50 / 74

7 Conversion
50 Festo – MPAC-VI-EN – 2017-12a – English
Extension
An extension of the valve terminal by one of more manifold sub-bases means that the tie rod system
must be extended. To do this, a corresponding number of extension pieces are screwed in between
the threaded rod and threaded sleeve. For manifold sub-bases or pneumatic supply plates, a corres­
ponding extension piece is available:
Product type
VMPAC-ZAE-14 Extension piece for one manifold sub-base
Tab. 7.1 Extension piece for tie-rod system
7.2 Replacing or extending the manifold sub-base, supply plate
or replacing the right end plate
If manifold sub-bases are used only with electronics modules of the same type (
è
Chapter 2.4.1),
the following maximum number
of valve positions results (
è
Tab. 7.2):
Controllable solenoid coils per valve position max. number of valve positions
1)
1 32
2)
2 16
3)
1) For manifold sub-bases with electronics modules of the same type
2) Maximum of 24 manifold sub-bases for valve terminal with Sub-D multi-pin plug connection with 25 pins (
è
Tab. 2.1)
3) Maximum of 12 manifold sub-bases for valve terminals with Sub-D multi-pin plug connection with 25 pins (
è
Tab. 2.1)
Tab. 7.2 Maximum number of manifold sub-bases
Dismounting
1. Loosen the electric and pneumatic connections and then remove the valve terminal from its mount­
ing surface (
è
Chapter 3.1).
2. Place the valve terminal on a flat working surface.
3. Loosen and remove the five screws of the tie rod on the right end plate using a size 6 ring spanner
(
è
Fig. 7.2). The loosened manifold sub-bases are now only held in place by the electrical linking.