Festo HMP-x-B Series, Руководство по эксплуатации

Страница: 36 / 56

HMP−...−B−...
Festo HMP−...−B−... 0408NH English
36
S
Fasten the work load in one of the follow
ing ways:
Dovetail fastening
Sliding block fastening (only with
HMP−25/32−...; sliding blocks see
Accessories)
Direct fastening
Fitting pneumatic components
S
Note that the compressed air connections are exhaust−restricted at the factory.
Controlling linear module type HMP−...−B:
S
Use a 5/2−way valve (pressurized in basic
position).
If fitted in a vertical or sloping position:
S
Check whether non−return valves with
control of type HGL−... (with high flow
rate) are necessary.
Otherwise the work load will slide down if
there is a drop in pressure.
S
Check whether a compensation reservoir
type VZS−... is required.
This will reduce fluctuations in pressure in
the downstream−switched compressed air
string.
S
Connect the pneumatic tubing as follows
(Fig.15):
Port A (connection extending)
Port E (connection retracting)
Fig.13
Fig.14
E A
Fig.15
(E)
(A)