Festo CPX-AP-A-8DO-M12-5P, Руководство по эксплуатации

Страница: 8 / 16

8 Festo — CPX-AP-A-8DO-M12-5P — 2022-07
Parameterisation
Response of the display components of the module after error-free commissioning
[MD] [PL]
green light green light
Tab. 5: Response of the LED displays of the module after error-free commissioning
Information on troubleshooting in the event of incorrect response:
è 9 Diagnostics and fault clearance
è
1.1 Applicable documents
8 Parameterisation
Various parameters are available for reading out information about the modules in an automation
system CPX-AP-A and for adapting the modules to the application situation.
Write access to the parameters is typically performed by the higher-level controller using the device
descriptions specific to the host system.
ID Parameter Instances Data type Access
1
)
Array
size
246 Fieldbus serial number 1 UINT32 ro –
791 Product key 1 CHAR ro 12
960 Firmware version 1 CHAR ro 30
20000 Module code 1 UINT32 ro –
20010 AP-ASIC hardware version 1 UINT16 ro –
20011 libAP version 1 CHAR ro 30
20022 Configuration of load supply voltage moni-
toring (PL) 1 ENUM_ID rw –
20052 Response in the error state 1 ENUM_ID rw –
20069 CRC error counter 3 UINT16 ro –
20070 Incorrect AP slot count 3 UINT16 ro –
20081 Mask for forcing the outputs 1 UINT8 rw –
20082 State of the outputs to be forced 1 UINT8 rw 1
20083 Force LED states 1 UINT16 rw 1
20085 Measured value of temperature AP-ASIC [°C] 1 INT16 ro –
20087 Current measured value of logic supply (PS) 1 UINT16 ro –
20088 Current measured value of load supply (PL) 1 UINT16 ro –
20089 Quality of the transmission line 3 UINT16 ro 17