Festo CPS-Gate, Руководство по эксплуатации

Страница: 46 / 109

CPS Gate
46
© Festo Didactic 8075265
•
Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the cable and the fuse.
– If these are not the same, use a separate upstream fuse in order to provide appropriate overcurrent
protection.
•
Use only connecting cables with safety plugs for electrical connections.
•
When laying connecting cab les, make sure they’re not kinked or pinched.
•
Do not lay cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
The device is not equipped with an integrated fuse unless otherwise specified in the technical data.
•
Always pull on the safety plug when disconnecting cables – never pull the cable.
•
In the event of
– visible damage,
– malfunction,
– inappropriate storage or
– incorrect transport,
safe operation of the device is no longer possible.
– Switch off the power supply immediately.
– Protect the device against inadvertent restart.
Pneumatic safety
•
Depressurize the system.
– Switch off the compressed air supply before working on the circuit.
– Check the system with pressure gauges to make sure that the entire circuit is fully depressurized.
– Please note that energy may be stored in reservoirs. Further information on this issue is available in
the data sheets and operating instructions included with the components.
•
Do not exceed the maximum permissible pressure of 600 kPa (6 bar).
•
Do not switch on compressed air until all tubing connections have been established and secured.
•
Do not disconnect tubing while under pressure.
•
Risk of injury when switching compressed air on!
Cylinders may advance and retract automatically.
•
Risk of accident due to advancing cylinders.
– Always position pneumatic cylinders so that the piston rod’s working space is unobstructed over
the entire stroke range.
– Make sure that the piston rod cannot collide with any rigid components of the setup.
•
Risk of accident due to tubing slipping off.
– Use shortest possible tubing connections.
– In the event that tubing slips off: switch compressed air supply off immediately.