5
ELECTRIC CONNECTION
The appliance is connected to the electric
socket (single phase, 230V, 50 Hz) using
the connecting lead of the appliance. The
fuse size for the socket is 10 A. Any alte-
rations to the connection method or chan-
ging of the connecting lead must only be
done by an electrician.
A suitable place for the socket is in the
back wall at the location of the refrigera-
tor, at a height of 2060 mm from the floor
to the lower edge of the socket. The
socket can also be situated at a corres-
ponding place in the ceiling, at a maxi-
mum of 500 mm from the back wall.
Any excess length of connecting lead
must not be pushed into the back cavity,
but must be left on top of the appliance.
Do not situate the appliance in a small,
poorly ventilated place. Faultless operati-
on of the mechanism requires good venti-
lation. The air inlet at the front of the app-
liance, below the door, must not be cove-
red.
AN AIR CIRCULATION GAP OF 40 mm
MUST BE LEFT ABOVE THE APPLIAN-
CE (see operational description / air cir-
culation, page 8, picture).
The floor where the appliance is situated
must be even and horizontal, and at the
same level as the surrounding floor.
In the cooling cabinet, ice formed on the
expansion coil melts automatically and the
resulting water is conducted to the evapo-
ration trough in the compressor area,
from which it evaporates automatically.
If there will be any functional disorder it is
possible that there will be water leakage
under the appliance.
That is why we recommend to install a
protective cover to the floor where the
appliance will be situated.
The floor cover can also be ordered from
Festivo-service.
The refrigerator-freezer combination can
be situated against the background surfa-
ce and side surfaces, but if the side surfa-
ce comes next to another cold storage
appliance or an outside wall, then a venti-
lation gap of at least 1 cm must be left bet-
ween the surfaces concerned.
No other appliances or furniture must be
fixed to the appliance, because it has to
be possible to pull it out for cleaning and
servicing.
If the appliance is situated to the corner,
there must be a gap between the cabinet
and wall. Otherwise the door doesn't open
90°.
Min.60mm
