Fervi t047/230v, Руководство пользователя и по обслуживанию

Страница: 8 / 52

MACHINES AND
ACCESSORIES
Page 8 of 43
to avoid damage to persons, to the property or to the machine itself.
 Please use the machine only for its expected uses (drilling or tapping).
 Don't tamper with the safety devices equipping the machine.
Operator Protection
Before starting any work on the machine, the operator must wear the appropriate personal
protective equipment (PPE) such as gloves and eye protection (see section 6.5 of this
manual).
1. Always check the efficiency and integrity of the machine.
2. Before connecting the machine to the mains, make sure that the rotating parts are not
damaged or badly worn. Make sure that the switch is in the neutral position.
3. Do not start the machine in an enclosed or poorly ventilated area, or in the presence of a
flammable and/or explosive atmosphere. Do not use the machine in damp and/or wet
locations, or those exposed to rain.
4. Avoid starting accidentally.
5. Before starting the machine, get used to ensuring that no remaining maintenance and
service keys are inserted.
6. Keep the workplace tidy and free from obstruction; disorder causes accidents.
7. Make sure that your work environment is forbidden to children, strangers and animals.
8. Do not perform tasks on the machine other than those for which it was designed. Only
use the machine in the manner in which it was intended, as described in this instruction
manual.
9. Work without disturbances.
10. Work areas must be well lit.
11. Always wear eye protection and protective gloves while working. If dust is produced, use
the appropriate masks.
12. Wear appropriate clothing. Loose clothing, dangling jewelry, long hair, etc.., can get
caught in the spindle and moving parts, causing irreparable injury.
13. Firmly secure the workpiece before starting the drill.
14. Always use the tool (tip or tap) in an appropriate manner. Perform only the work for
which the tool is made. Do not use the tool for inadequate work.
15. Only use suitable resistance tools in relation to the work that is to be done. This is to
avoid risky and unnecessary overloading for the operator, which may be harmful for the
life of the tools themselves.
16. Do not pick up moving tools or other moving parts. To stop the spindle on the machine,
always only use the stop command device.
17. 17. Do not remove the shavings from the table with hands, even at a standstill. To do
this, use tongs or a palette knife.
18. When the cutting tools need to be replaced or the speed needs to be changed, stop the
motor and wait for the spindle to stop.
19. Do not leave the machine until the spindle and the tool are completely stopped.
20. After the work is completed, clean the tool and check its efficiency.
21. Replace worn and/or damaged parts, check that the repairs and protections work properly
before operating. Eventually, if necessary, have it checked by Service staff. Use only
original spare parts.
22. Cut the mains voltage supply of the machine when:
 the machine is not being operated;
 it is left unattended;
 performing maintenance or registration, because the machine does not work properly;
fervi.com