MACHINE AND
ACCESSORIES
Page 16 / 26
Chamfering
After adjusting the machine it is possible to proceed with the chamfering of the edges.
Figure 10 – Chamfering.
For sharpening, proceed as follows:
Start the machine by pressing the green start button.
Figure 11 – Starting
Make sure the Portable chamfering machine is secured and apply a slight pressure to
the left end of the item to be processed, moving it to the right.
Press the confirmation button with the right hand thumb and the start button with the
index and/or middle finger as shown in Figure 5.
Note: If chamfering to a depth of 5 mm is required, begin by setting the machine at
a lower depth and perform two or more passes increasing the depth with each pass.
After chamfering the entire length of the edge, release the start button on the handle
then turn off the machine by pressing the red stop button.
Figure 12 – Stopping
The maximum chamfering depth (5 mm) is achieved only with an inclination of 45°, lower
inclinations correspond to lower depths.
fervi.com
