Ferroli TP3 LN 1060, Инструкция по использованию, установке и сборке

Страница: 40 / 76

40
EN
TP3 LN
cod. 3545458/0 - 10/2019
5.10 Assembling the panels, models 240-2360
Assembly sequence (Fig. 12)
a) Position the side panels (pos. 1-2 and 3-4) hooking them to the supports (pos. 19).
b) Position the top right panel (pos. 5-6) and then the left panel (7-8) hooking them to the supports on the boiler (pos. 19) and to the crossbeam
(pos. 15).
c) Fasten the control panel to the top right panel (pos. 5).
d) Rest the top panel (pos. 5), complete with the control panel, to the side panel (pos. 1) complete with springs, closing pins and nuts (pos.
12-13-14).
e) Insert the bulbs of the instruments into the sheats as shown in Fig. 19 and make the electrical connection between the control panel and the
power line, burner and any pumps etc. The probes should be inserted fully into the corresponding sockets, to improve contact. Then secure
the capillary tubes with the springs. Close the cover on the electrical panel, pass the burner plug through the side plate (pos. 10) and secure
the cable with the cable gland supplied. Fasten the plate (pos. 10) with the screws (pos. 11).
f) Fit the support (pos. 15).
g) Fit the top panels (pos. 5-6-7-8) hooking them to the side panels (pos. 1-2-3-4) complete with springs, closing pins and nuts (12-13-14).
h) Fasten the rating label to the boiler, see Chap. 1, after having cleaned and degreased the part in question using a suitable solvent, and apply
it so as to ensure perfect adhesion. Do not remove the rating label, as it will lose its adhesiveness.
The rating label is included in the document envelope.
1
2
3
4
5
6
7
8
10
11
12
13
14
15
9
11
19
fig. 12