Ferroli FCS-C Series, Руководство по установке

Страница: 34 / 52

34
BEFORE INSTALLATION
Transporting the unit packed as close as possible to the place of installation.
IMPORTANT: Do not move the unit through the exhaust pipe of the condensate or attacks; grasp on
the four corners .
The installation of the unit will be facilitated using un’elevatore The fan must be installed in a position to allow
routine maintenance and repairs, as well as access to the air vent valve on the side of the unit (housed in the
water connections). (See figure 1-2 position indication hatch )
In the case of plasterboard false ceilings the housing unit must be no larger than 660x660 mm (for models 200-
300-400) and 900x900 (for models 500-600-700).
In the case of environments with high humidity, isolate the hanging brackets with the appropriate insulating
adhesive supplied.
The following tools are required in order to install the
convector fan:
· Pipe wrench for the wet connections
· Flat tip and cross-headed screwdrivers
· Drill
· Scissors
· Wire stripper
· Pipe cutters
· Pipe benders
· Measuring tape
· Level
· Goggles and protective gloves
The following items are also required for installation purposes:
· Water pipe unions
· Condensation-proof tape
· Adhesive tape
TOOLS REQUIRED FOR INSTALLATION
ACCESSORY PARTS NORMALLY AVAILABLE ON THE MARKET AND REQUIRED FOR INSTALLATION
max 660
max 660 max 900
max 900
max 660
max 660 max 900
max 900
Mod .04-08-10 Mod .12-16-20
Fig. 1 Fig. 2
INSTALLATION