Manuale utente
pag. 14 / 15
Fig. 8 – Removal of the anode
4.7
Emptying the boiler
It is advisable to drain the water from inside the
boiler if the boiler is idle for a certain period of time,
especially in low temperatures.
As for the equipment in question, it is sufficient to
disconnect the water supply input connection).
Alternatively, during the system installation stage, it
is advisable to install a drain tapwith a hose-
holding connection.
N.B.: It is important to empty the system
in case of low temperatures in order to
avoid the water freezing.
5
TROUBLESHOOTING
In case of problems of equipment performance,
without the occurrence of any of the alarms or
errors described in the relative paragraphs, it is
advisable to check to see if the problem can be
easily solved by checking the possible solutions
specified in the table below prior to seeking
technical assistance.
Problem
Possible causes
The heat pump does
not work
There is no electricity;
The plug is not correctly
inserted in the socket.
The compressor and/or
the fan do not work
The set safety period of
time has not finished;
The
scheduled
temperature has been
reached.
The heat pump
continuously switches
itself on and off
Wrong programming of
the
parameters/setpoint
and/or
hysteresis
values.
The heat pump remains
continuously switched
on and does not switch
off
Wrong programming of
the parameters/set
point and/or hysteresis
values.
The electric heating
element does not
switch on
Your intervention is not
required
WARNING! In the event that the
operator does not succeed in solving
the problem, switch off the equipment
and seek technical assistance
specifying the device model
purchased.
6
DISPOSAL
At the end of their device lifecycle, the heat
pumps will be disposed of in conformity with the
applicable regulations.
WARNING! This equipment contains
greenhouse fluorinated gas included in
the Kyoto protocol. The maintenance
and disposal operations must only be
carried out by qualified personnel.
INFORMATION TO USERS
Pursuant to EU Directives 2002/95, 2002/96 and
2003/108, relating to the reduction of the use of
hazardous substances in electric and electronic
equipment as well as waste disposal “.
The symbol of the barred wheelie-
bin that can be seen either on the
equipment or its packaging
indicates that the device must be
collected separately from other
waste at the end of its lifecycle.
At the end of the device lifecycle,
the user must therefore take the
equipment to suitable separate
Mg Anode
Anode gasket
¾”
