Ferris ISX800Z Series, Руководство оператора

Страница: 24 / 32

Not for
Reproduction
24 ferrismowers.com
Ground Speed Control Lever Adjustment
The control levers can be adjusted in three ways. The
alignment of the control levers, the placement of the levers
(how close the ends are to one another) and the height of the
levers can be adjusted.
To Adjust the Handle Alignment
Loosen the mount bolts (A, Figure 25) and pivot the lever(s)
(C) to align with each other.
25
To Adjust the Handle Placement
Loosen the jam nuts and adjust the placement bolt (B) in or
out to properly adjust the lever end spacing.
To Adjust the Handle Height
Remove the mounting hardware and reposition the handle
either up or down from its original position. You will need to
readjust the handle alignment as described above.
Cutting Height Adjustment
The cutting height adjustment pin (A, Figure 26) controls
the mower's cutting height. The cutting height is adjustable
between 1-1/2" (3,8 cm) and 5” (12,7 cm) in 1/4” (0,64 cm)
increments.
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
26
To set the cutting height at 1-1/2” (3,37 cm):
1. While sitting in the operator’s seat, press the deck lift
foot pedal (C) forward until it locks into the 5" (12,7 cm)
position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the deck lift foot pedal forward and then push the
lock lever (D) towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to
rest against the stationary pin (E) in the 1-1/2” (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in the storage
hole (F).
To set the cutting height in the range of 1-3/4” (4,40 cm)
and 4-3/4” (12,06 cm):
1. While sitting in the operator’s seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Press the deck lift pedal forward and then push the lock
lever towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. While sitting in the operator’s seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 5" (12,7 cm) while cutting.
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position: