Ferris 5901852, Руководство оператора

Страница: 30 / 52

Not for
Reproduction
30 ferrismowers.com
wood can be used to support the operator support cushion in
the upright position while servicing the components beneath
the control tower.
29
Fuse Location and Identification
The electrical system for this unit is equipped with two
replaceable fuses. See the chart below for the circuit,
amperage, and approximate location of the fuses.
Circuit Amperage Approximate
Location
Main 20 amp Mounted by the battery
box on the right hand
side of the machine.
PTO (Power Take Off)
Clutch
15 amp Mounted under the
control panel on the
right hand side of the
machine
Check / Fill Transmission Oil Level
Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A,
Figure 30). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
30
1. Locate the transmission oil tanks. The transmission oil
tanks are located on the right side of the engine between
the engine and the battery box.
2. Check the oil level when the unit is cold. The oil should be
up to the “FULL COLD” mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step #3.
3. Before removing the tank cap (C), make sure that the
area around the tank caps and fill neck of the tank is free
of dust, dirt, and other debris. Remove the tank caps.
4. Add oil up to the “FULL COLD” mark.
5. Re-install the tank caps.
6. After adding oil to the tanks, it may be necessary to purge
air from the hydraulic system. If the unit is not driving
properly perform the Purging the Air from the Hydraulic
System procedure.
Transaxle Oil Filter Change
Change Interval: Every 400 Hours or Yearly (Initial transaxle
oil and filter change after first 100 hours of operation).
Replacement Filter Number: 5101026X1
Note: Removing the oil filter from the transaxle will drain
the oil in the oil tank and the lines routed to the oil cooler.
Have a suitable container ready to catch the drained oil. The
manufacturer recommends that this be a dealer-only service
item.
1. Park the unit on a flat, level surface such as a concrete
floor. Engage the parking brake, disengage the PTO, turn
the ignition switch to OFF, and remove the ignition key.
2. Chock the front tires of the unit. Raise the rear of the unit
so that the rear tires clear the ground and secure the unit
with jack stands.
3. Remove the foot guard (A, Figure 31) and the hardware
that retains it to the back of the unit.