Ferris 5901852, Руководство оператора

Страница: 27 / 52

Not for
Reproduction
27
Carbureated Models: The fuel filter is located in the fuel line
between fuel tank and carburetor, near the fuel pump.
Fuel Injected Models: The fuel filter is located in the fuel line
between the fuel tank and fuel pump.
If filter is dirty or clogged, replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using a pliers, open and slide hose clamps from fuel filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.
Check Engine Oil Level
Interval: Before Each Use
Refer to the engine operator's manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
Briggs & Stratton Vanguard Engines
with Remote Oil Tank (Select Models)
Some models in this series of mower feature a remote oil tank
(A, Figure 24) that supplies oil to the engine. Units equipped
with a Vanguard engine with remote oil tank are factory filled
with specially formulated Vanguard 15W-50 synthetic oil.
Note: This specific grade of oil is not required to keep engine
warranty in effect.
For more information regarding this engine and other
operational and maintenance information, please refer to the
engine operator's manual included with your unit.
24
Changing the Engine Oil and Filter
(Engines with Remote Oil Tank)
Engine Oil Type: 15W-50 synthetic oil. (See the engine
operator's manual for other oil recommendations.)
Engine Oil Change Amount: 5 qt (4,73 L).
Oil Change Interval: Every 500 hours.
Important: Always make sure that the mower is parked on a
flat, level surface when checking the engine oil level.
1. Park the machine on a flat, level surface. Engage the
parking brake and disengage the PTO. Allow the engine
to run until it is warm. This will warm the oil so it will
drain better. Turn the ignition switch to OFF, remove the
ignition key, and wait for all moving parts to stop before
leaving the operator's position.
2. Clean the area around the engine oil dipstick (A, Figure
25) and oil fill cover (B) to remove any debris.
25
3. Remove the engine oil dipstick and wipe with a clean
cloth.
4. Cut the self-locking tie (C) that keeps the oil fill cover
securely closed. Open the oil fill cover.
5. Have a suitable container ready to capture dripping oil
from the engine oil filter (D) after it is removed. Remove
the oil filter by turning it counter-clockwise a 1/4 turn (E)
and then pulling up. Dispose of the used oil filter properly.
6. This mower is equipped with an oil drain valve (A, Figure
26) that is used to drain the oil from the remote oil tank.
The drain is located at the end of the oil drain hose (B)
which is connected to the bottom of the remote oil tank
(C). There is a clamp on the left hand side of the control
tower where the oil drain hose is stored when not in use.