Ferris 500S Series, Руководство оператора

Страница: 30 / 36

Not for
Reproduction
30 ferrismowers.com
40
Although it is fastened with a multi-position anchor, this is not
an adjustment point .
NOTICE Do NOT attempt to adjust the spring length or
lifting performance will be compromised.
Mower Deck Drive Belt Replacement
NOTICE To avoid damaging belt, do not pry over pulleys
1. Park the mower on a flat, level surface, such as a
concrete floor. Disengage the PTO, engage the parking
brake, turn off the ignition, and remove the key.
2. Lift the deck to the TRANSPORT position. Remove the
mower deck guards and floor pan to gain access to the
mower deck drive belt.
WARNING
Use extreme caution when rotating the idler arm with the
breaker bar, due to the increased tension in the spring
as the idler arm is being rotated. Injury may result if the
breaker bar is prematurely released while the spring is
under tension.
3. Using a 1/2" breaker bar, place the square end in the
square hole located in the idler arm (A, Figures 41 & 42).
Carefully rotate the breaker bar clockwise , which will
relieve the tension on the belt exerted from the idler arm.
41
42
4. Slide the drive belt (B) over the edge of the rear
stationary idler pulley (C). Carefully release the tension
on the breaker bar.
5. Remove the old belt and replace with a new one. Make
sure that the V-side of the belt runs in the spindle pulley
(D) grooves.
6. Install the drive belt on the PTO pulley, the spindle
pulleys (D), the front stationary idler pulley(s) (E), and the
adjustable idler pulley (F). Carefully rotate the breaker bar
clockwise and install the belt on the rear stationary idler
pulley (C).