Ferris 500S Series, Руководство оператора

Страница: 27 / 36

Not for
Reproduction
27
31
Ground Speed Control Lever Adjustment
1. Loosen the ground speed control lever mounting
hardware (A, Figure 32) to adjust the levers forward and
backward.
2. Remove the hardware to raise or lower the levers.
3. Always be sure to adjust both levers so that they are
aligned (B, Figure 32).
4. After adjustment is complete, tighten the hardware to 13
lb-ft (18 Nm).
32
Speed Balancing (Tracking) Adjustment
If the rider drifts to the right or left when the ground speed
control levers are in the maximum forward position, the top
speed of each of these levers can be balanced. Only adjust
the speed of the wheel that is traveling faster.
1. Tighten the knob (A, Figure 33) of the faster wheel by 1/2-
turn (clockwise) increments until the rider travels (tracks)
straight.
WARNING
Unsafe Operation Hazard
DO NOT adjust the rider for a faster overall speed forward
or reverse than it was designed.
33
Checking Tire Pressures
Tire pressure should be checked periodically (see
Figure 34), and maintained at the levels shown in
the Specifications chart. Note that these pressures may
differ slightly from the "Max Inflation" stamped on the side-
wall of the tires. The pressures shown provide proper traction
and extend tire life.
34
Cutting Height Adjustment
The deck lift pedal adjusts the mower cutting height. The
cutting height is adjustable between 1-1/2" (3,8 cm) and
4-1/2" (11,4 cm) in 1/4" (0,64 cm) increments.