37
•
In cases of stubborn dirt, use a damp
cloth and a little soft soap.
8.2 Carbon brushes
In case of excessive sparking, have the
carbon brushes checked by a qualifi ed elec-
trician.
Danger!
The carbon brushes should not be
replaced by anyone but a qualifi ed electri-
cian.
8.3 Maintenance
WARNING! Risk of injury!
There is a risk of serious injuries if the
bench-type circular saw is handled impro-
perly.
•
Switch off the bench-type circular saw
and pull the power plug out of the so-
cket before you start any maintenance
work.
•
Wear suitable protective gloves when
carrying out work on the bench-type
circular saw.
•
There are no parts inside this bench-ty-
pe circular saw which can be repaired
by the user. Never try to repair the
bench-type circular saw yourself. Al-
ways contact a qualified expert.
NOTE! Risk of damage
The ingress of water into the housing could
cause a short-circuit.
•
Never immerse the bench-type circular
saw in water.
•
Ensure that no water gets into the hou-
sing.
Correct and regular care is not only import-
ant for safe use, it will also contribute to
a longer service life for your bench-type
circular saw.
Inspecting the bench-type circular saw
Inspect the bench-type circular saw regular-
ly to check its condition.
Among other things, check whether:
•
the switches are undamaged,
•
the accessories are in perfect condition,
•
the power cable and the power plug are
undamaged,
•
the ventilation slots are clear and clean.
Use a soft brush or a brush with bristles
to clean them if necessary.
If you fi nd any damage, you must arrange
for it to be rectifi ed by a service center to
prevent hazards.
F_TS_2000_1_GB_SPK7.indb 37
F_TS_2000_1_GB_SPK7.indb 37
04.06.2019 10:19:01
04.06.2019 10:19:01
