27
4. You can use the knurled screw (30) to
adjust the width of the table width ex-
tension on an infi nitely adjustable basis
as far as the end stop.
5. Carefully turn the saw table over and
set it down with its legs on the fl oor.
Fitting/adjusting the splitter (Fig. 14-19)
WARNING! Risk of injury!
If the bench-type circular saw is started up
by accident or the saw blade is handled in-
correctly, there is a risk of serious injuries.
•
Always pull the power plug from the so-
cket outlet before making adjustments
to the bench-type circular saw.
•
Always wear protective gloves when
handling the saw blade or working in
its immediate vicinity. Check the splitter
(4) every time after you have changed
the saw blade and align it correctly if
necessary.
1. Make sure that the saw blade (30) is lo-
wered to the maximum in the saw table
(1). To lower the saw blade if necessary,
turn the crank (32) counterclockwise as
far as the stop.
2. Remove the two fastening screws and
remove the table insert (5) from the
saw table. When you do so, always
check the table insert: Replace the table
insert immediately if it is damaged or is
no longer fl ush with the saw table.
3. Make sure that the angle adjustment
facility of the saw blade is set to 0°. If
necessary, adjust the angle adjustment
facility as described in the section “Set-
ting the cutting angle”.
4. To turn the saw blade out of the saw
table as far as the maximum, turn the
crank clockwise as far as the stop.
5. Undo the clamping screw (33) using a
size 10 wrench (12) by turning it several
revolutions counterclockwise.
6. Insert the splitter behind the clamping
plate (34) and push it down to the ma-
ximum.
7. Turn the clamping screw several revolu-
tions clockwise to screw it tight.
8. Align the splitter so that there is a
gap of 3-5 mm to the saw blade at all
points.
9. Secure the splitter by turning the clam-
ping screw clockwise again to tighten it.
10. To turn the saw blade into the saw table
as far as the maximum, turn the crank
counterclockwise as far as the stop.
11. Pull the table insert slightly apart and
push it over the laser and splitter again.
Insert the lug on the rear end of the ta-
ble insert into the corresponding groove
on the saw table and then lower the
F_TS_2000_1_GB_SPK7.indb 27
F_TS_2000_1_GB_SPK7.indb 27
04.06.2019 10:19:01
04.06.2019 10:19:01
