34
5. Push the cross stop and the workpiece
toward the blade in order to make the
cut.
6. Switch off the bench-type circular saw
and the vacuum extraction system.
7. Leave the off -cut piece on the saw table
until the saw blade is back in its posi-
tion of rest.
Cutting particleboard
To prevent the cutting edges from cracking
when working with particleboards, do not
set the saw blade (31) more than 5 mm hig-
her than the thickness of the workpiece.
After sawing
1. Switch off the bench-type circular saw
by pressing the red operating switch 0
(43).
2. Wait until the saw blade (31) has rea-
ched a complete standstill and then
take the workpiece off the saw table
(1).
3. Disconnect the bench-type circular saw
from the mains power supply by pulling
the power plug out of the socket.
4. Allow the bench-type circular saw to
cool down completely.
Removing jammed material
WARNING! Risk of injury!
There is a risk of serious injuries if the
bench-type circular saw is handled impro-
perly.
•
Switch off the bench-type circular saw
immediately and pull the power plug
out of the socket if the saw blade has
got jammed in the workpiece or if any
other blockages occur.
•
Wear protective gloves, do not touch
the saw blade with bare hands.
Changing the saw blade (Fig. 29)
WARNING! Risk of injury!
Warning!
Always disconnect the power plug before
you change the saw blade!
There is a risk of serious injuries if the
bench-type circular saw is handled impro-
perly.
•
Wear protective gloves, do not touch
the saw blade with bare hands.
1. Remove the two fastening screws and
remove the table insert (5) from the
saw table. When you do so, always
check the table insert: Replace the table
insert immediately if it is damaged or is
no longer fl ush with the saw table.
2. Make sure that the angle adjustment
facility of the saw blade is set to 45°. If
F_TS_2000_1_GB_SPK7.indb 34
F_TS_2000_1_GB_SPK7.indb 34
04.06.2019 10:19:01
04.06.2019 10:19:01
