FERREX CHAINSAW 4-STROKE, Руководство пользователя

Страница: 37 / 50

Kapitelüberschrift
41
Cleaning
m
CAUTION
Set the stop switch (Fig.1 / pos. 14) ‘0’ stop before doing any cleaning and main-
tenance work!
Carrying out any cleaning work
-
The equipment should be cleaned thoroughly every time after it has been used.
This applies particularly to the chain and bar.
-
Keep the air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean damp cloth or blow it down with compressed air
at low pressure.
-
It is easiest to remove sawdust and wood chippings immediately after use.
-
Clean the equipment regularly with a damp cloth and some soft soap. Do not use
cleaning agents or solvents; these may be aggressive to the plastic parts in the
equipment. Ensure that no water can get into the interior of the equipment.
Maintenance and servicing
MAINTENANCE
m
CAUTION
All maintenance work on the chainsaw apart from the work described in this manual
may only be carried out by authorised after-sales service personnel.
Chain brake operational test
Test the chain brake periodically to ensure proper function. Perform a chain brake
test prior to initial cutting, following extensive cutting, and definitely following any
Chain brake service.
Test chain brake as follows:
1.
Place saw on a clear, firm, flat surface.
2.
Start the engine.
3.
Grasp the rear handle with your right hand.
4.
With your left hand, hold the front handle (Fig. 1/pos. 4) (not chain brake lever /
front hand guard / pos. 3) firmly.
Cleaning/Maintenance and servicing