FERREX CHAINSAW 4-STROKE, Руководство пользователя

Страница: 30 / 50

Kapitelüberschrift
34
Always pull out the starter handle (16) in a straight line. If it is pulled out at an an-
gle, friction will occur on the eyelet.
As a result of this friction, the starter handle (16) will become frayed and will wear
away faster. Always hold the starter handle (16) when the starter line retracts.
Starting the engine when warm (Fig. 12 / 13)
(The equipment has been idle for less than 15-20min)
1.
Activate the chain brake lever (3) before starting.
2.
Make sure the stop switch (14) is in the ‘I’ (ON) position.
3.
Set the chainsaw down on a firm level flat surface. Hold the saw firmly as
shown. Beware of moving chain!
4.
Pull the starter handle (16) rapidly 4 times. The engine should start. If the
chainsaw does not start after 4 tugs, repeat the steps of the procedure for start-
ing the engine from cold.
Each time before use, check the following:
-
That there are no leaks in the fuel system.
Switching off the engine (Fig. 12)
Emergency Stop procedure:
To stop the engine in an emergency, activate the chain brake lever / front hand
guard (3). This will immediately stop the chain. Then switch the stop switch (14) to
‘0’ Stop.
Normal procedure:
Let go of the throttle lever (7) and wait until the engine has changed to idling
speed. Then set the stop switch (14) to ‘0’ Stop.
Practice all the work steps with the engine switched off before you start to use the
chainsaw.
m
CAUTION
When idling, the saw chain (2) should not move. If the saw chain (2) moves, you need
to adjust the idling speed!
Operation