5
Change the parameters
Numeric parameters: press "Enter” (o) and the parameter name will start blinking. Now you can
change the parameters with ▲ and ▼ . Once the correct parameter is set, press "Enter” (o) to
confirm.
Parameters to be selected: Press "Enter” (o) to change the selection and find the one required
Simultaneously press ▲ and ▼ on any programming page for at least two seconds to save the
settings and go back to the work menu.
Simulation
with feedback (“Simulation Fbk”):
On this page you can enable or disable the “Simulation with feedback” mode that allows you to
simulate the work. In particular, this mode is used to simulate movement of the transplanting
bodies at a certain travel speed.
Press "Enter” (o) to enable (or disable) simulation: the word OFF is replaced with an analogue bar
that indicates the simulation speed in km/h. Use ▲ and ▼ to increase or decrease the speed.
Simulation
without feedback (“Sim No
Fbk”):
On this page you can enable or disable the “Simulation without feedback” mode that allows you to
activate movement of the transplanting bodies. In particular, this mode is used to excite the
proportional valve with a constant level of voltage that can be set, without feedback from the
rotation sensor (encoder) and therefore without reference to the transplanting speed.
Press "Enter” (o) to enable (or disable) simulation: the word OFF is replaced with an analogue bar
that indicates the simulation speed in km/h. Use ▲ and ▼ to increase or decrease the speed.
