Ferplast CAYMAN LED PROFESSIONAL 110 страница 4 Скачать руководство пользователя

Страница: 4 / 32

CAYMAN LED glass aquariums

IMPORTANT WARNINGS

Before performing any operation, please

read the following instructions carefully for your

safety and to prevent damage to the aquarium:

• Ensure that the voltage shown on the all

electrical components corresponds to that of

your home electrical power supply.

• The aquarium is intended only for indoor use.

• Before switching on make sure your home is

protected by an automatic safety breaker switch

(or individual breaker plug) with an operating

current of no more than 30 mA.

• Do not connect the aquarium to the power

supply before correctly completing all the

installation procedures, including filling with

water.

• Always disconnect all appliances from the

electric power supply before carrying out any

maintenance.

• Remember that the protection of the lights

from water and dust is guaranteed only when

the fluorescent tubes are correctly inserted and

the ring nuts perfectly tightened.

• The lights must never be submerged.

• The power cable has Y-type wiring, so if

damaged it must be replaced by a qualified

electrician.

• All special maintenance work must be carried out

by a qualified electrician. ‘Special maintenance’

means any kind of work not included in the

paragraph ‘Maintaining the CAYMAN aquarium’

and ‘Maintaining the BLUWAVE filter’. ‘Qualified

electrician’ means any qualified member of the

• Never remove the heater (if present) from the

water when it is connected to the electric power

supply. Before removing the heater, disconnect

it and leave it to cool inside its housing for at

least 5 minutes.

• Check that the Bluwave filter intake grilles are

not blocked.

• Always ensure that the water level stays above

the minimum level and below the maximum;

both are marked on the front of the BLUWAVE

filter. Remember that the water level should

always be between the MIN and MAX levels,

both shown on the front of the BLUWAVE filter.

• Do not pour liquid onto the overtank lamp

because it contains electrical parts:

• Do not damage the silicone cord with scissors,

pliers, brushes or scrapers;

• Do not use detergents, solvents or chemical

products (descaler, ammonium-based

products, etc.) to clean the glass, as they could

damage the silicone, causing it to become

detached (possibly some time later);

• Do not use adhesives or adhesive tape near the

silicone when applying backgrounds. Moreover,

you should always use a spirit level to make sure

that the aquarium is placed on a perfectly flat

surface in both directions (length and depth), so

as not to break the glass or damage the silicone.

Check that all parts are undamaged (lights, heater, glass and plastic parts,
etc.). Ferplast uses strong, secure packaging and checks each aquarium
individually, but we recommend you also check that no accidental
damage has occurred during transport, storage or sale which could affect
its watertight seal and safe use.