Ferm GGM1003, Оригинальное руководство пользователя

Страница: 3 / 32

3
EN
For the charger
Intended use
Charge only 7.2V max.1.5Ah Li-ion type
rechargeable battery packs. Other types of
batteries may burst causing personal injury and
damage.
a) The appliance is not to be used by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction
b) Children being supervised not to play with
the appliance
c) Do not recharging non-rechargeable
batteries!
d) During charging, batteries must be placed
in the well ventilated area!
Before operating the glue gun:
• A fire may result if the appliance is not used
with care, therefore be careful when using
the appliance in places where there are
combustible materials;
• do not apply to the same place for a long time;
• do not use in presence of an explosive
atmosphere;
• be aware that heat may be conducted to
combustible materials that are out of sight;
• place the appliance on its stand after use and
allow it to cool down before storage;
• do not leave the appliance unattended when it
is switched on.
• As hot glue can cause burns, avoid contact.
• Always allow the gun to cool down by itself.
• Never immerse the tool in water.
Immediately unplug the glue gun in case of:
• The glue gun is overheated.
• Broken switch.
• Smoke or smell caused by scorched
insulation.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the
wall outlet.
3. Operation
Always observe the safety instructions
and applicable regulations.
This glue gun (kit) has been especially designed
for glueing products such as wood, plastic, foam,
rubber, fabric, cardboard, tiles, ceramics, etc.
Quickly setting, the glue is perfect for repairing
carpets, bookbinding, fixing soles, etc. The glue is
waterproof and resistant to the action of many
liquids. The glue gun is quick, environmentally-
friendly, energy-saving and together with the glue
facilitates and quickens any job.
Charging the machine (with the charger
adaptor)
• Plug the small cable plug into the machine’s
charging socket.
• Plug the charger into an electrical outlet and
wait for a while. The LED indicator on he
machine will lighten up and show the charging
status.
Operation
• Press the button on the base of machine 2
seconds to switch on
• Insert a glue cartridge into the gun, two when
using it for the first time.
• Wait 15 seconds for the glue to heat.
• Squeeze the trigger to release the glue.
• Replace the glue cartridge as soon as you
notice little if any glue is released from the gun.
• Press the button again to switch off the tool.
• The machine will switch off automatically after
not being used for 4 to 5 minutes.
4. Service and maintenance
This machine has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Always switch off the tool before
cleaning and maintenance work. Never
use inflammable liquids to clean the tool.
Use a brush to clean the glue gun.
• Keep the nozzle clean. Check before every
use there is no glue left on the nozzle.
• Remove any glue left inside the nozzle with
a pin.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below: