Fenix AT-06B, Инструкция по эксплуатации

Страница: 15 / 24

15 15
ENGLISH
9. In case the lifting tower gets blocked at
any point during lowering process, there are
two options to try to unlock it. The first will
always be to raise all profiles to its maximum
to try to untangle the cable and release the
lifting tower. The other option will be if the
problem is due to the pendulum gets stuck in
one of the profiles. In this case, the solution
will be to release it by a sharp knock, using
if possible, an allen key in L, or any screw-
driver. Put the allen key in the lower slot of
the profile (N) that has been stuck and hit the
pendulum with a hammer, trying to unlock it
and release the lifting tower.
10. Lowering: To lower the profiles, follow
the opposite order. The first profile to be
lowered will always be the one located clo-
sest to the winch. To release the safety pins
(A), the load must be lifted slightly with the
winch. In the normal working position, the
weight of the load prevents the safety pins
(A) from being released. Once the safety pin
(A) is released, move it to the open position
(T), by doing (U) step. Then turn the winch
handle (B) slightly counterclockwise. Imme-
diately afterwards, move again the safety pin
(A) to closed position (S), until the end of the
section. Repeat the same steps successively
until it is completely folded to its minimum
height.
11. For the lifting tower transport, it is neces-
sary to bring down all profiles and place the
safety pins (A) in closed position (S). Move
the forklifts (E) in vertical position and lower
the carriage (X) by turning the winch handle
(B) and pressing down a little on the carriage
(X). Place the outriggers (H) in their trans-
port support (C) and retighten the plastic
knob (V). Fix the forklift (E) by placing the
pin (L) into the transport plate (F), securing
the carriage (X) to avoid the block of the pen-
dulum.
5. MAINTENANCE
1. Periodically check cable status. If the ca-
ble seems to have broken wires or crushing,
replace immediately with a new one. Never
use the lifting tower with cables in bad con-
ditions. Only use galvanized steel under EN
12385-4. Cable maximum load: 2.000kg. Ca-
ble torsion resistance: 1.770N/mm². Cable
diameter: 6mm. Cable composition: 6x19+1.
2. The lifting tower is supplied fully greased
from factory. Nevertheless, the crown gear of
the winch, to the threaded bar of the stabili-
ser outriggers and the profiles, because of its
use periodical greasing is recommended.
WARNING:
DO NOT GREASE OR LUBRICATE BRA-
KING MECHANISM
Braking disks were greased with a special
heat and pressure resistant grease. No other
product must be used to prevent negative in-
fluence on brake functioning.
3. Lifting tower AT-06B, must be checked by
an expert a minimum of once a year as per
its use.
4. Only original spare parts must be used to
ensure continued safe use. The user loses all
guarantee rights if spare parts other than the
originals are incorporated or the product is
modified in any way.
5. To request any spare part, contact the
manufacturer or an authorised distributor
within your territory.