Fender Passport Conference 2 Series, Руководство пользователя

Страница: 3 / 20

EN
GL
ISH
2
5. INPUTS: Connect microphones to channels 1, 2 and 3. Other
mono sound sources such as instruments can be connected
to any channel. Use channel 4/5 inputs for stereo/mono
sound sources such as keyboards, other line-level audio
sources, and mobile devices:
7. POWER UP: Turn on all external equipment connected to
Passport first, then turn Passport on. Power LED will illuminate
green:
9. SETTING LEVELS:
Connect a microphone or other sound
source and slowly turn up that channel's VOLUME control. LED
above VOLUME control will illuminate green when signal is
present. LED will illuminate yellow when signal is approaching
clipping level; LED will illuminate red when clipping
(distortion) occurs. For best performance, set VOLUME and
TONE controls so that LED is green and occasionally yellow.
If LED turns red, reduce VOLUME or TONE control settings.
If LED is still turning red after adjusting VOLUME and TONE
controls, press MIC/LINE button in:
Set up each channel the same way. Use channel VOLUME
knobs to adjust relative loudness of each channel until
reaching preferred overall balance, then use MASTER VOLUME
to adjust overall mix loudness.
6. INITIAL VOLUME: Turn MASTER VOLUME knob and all
channel VOLUME knobs fully counterclockwise to start:
8. SETTING MASTER VOLUME: Turn MASTER VOLUME up to
1/4 volume:
10. SETTING TONE:
Starting with each TONE control in the
center-detented position (flat equalization), set each TONE
control to preference for best clear and consistent sound
coverage throughout the area: