Fema S40-C1, Руководство пользователя, Страница: 15 / 28

FEMA ELECTRÓNICA . Series S . S40-C1
15
At the ‘
Password
’ (‘
PASS
’) menu select a 6 digit code to block access
to the ‘
configuration menu
’. Instrument configuration will not be ac -
cessible to non authorized personnel. To activate the ‘
Password
’ se-
lect ‘
on
’ and introduce the code.
The code will be requested when trying to access the ‘
configuration
menu
’ (key ‘SQ’ (
<
)). The ‘
fast access
’ menu is not password pro -
tected.
The ‘ Version ’ (‘ VEr ’) menu informs of the current firmware version
installed in the module.
At the ‘ Brightness ’ (‘ LIGh ’) menu select the light intensity for the
front leds. With this function it is possible to adapt the instrument to
the environment light intensity.
1.19.18 Vexc. control
Menus ‘
OPt.1
’ and ‘
OPt.2
’ give access to the ‘
configuration menus
’
of the output and control modules installed at slots Opt.1 and Opt.2.
Menu ‘
OPt.3
’ is not accessible as this instrument does not have slot 3.
See section
2
for a list of output and control modules available for
each slot. The ‘
configuration menu
’ of each module is described at
the User’s Manual of each module.
1.19.19 Function ‘Password’
At the ‘ Factory reset ’ (‘ FAct ’) menu, select ‘ yes ’ to load the default
factory configuration for the instrument
(see section 1.21).
1.19.20 Factory reset
1.19.21 Firmware version
1.19.16 Menus ‘Overrange / underrange’
The ‘ Counter overrange ’ (‘ c.orG ’) and ‘ Counter underrange ’ (‘ c.urG ’)
parameters configure the behavior of the instrument when reading
is higher than ‘9999’ (overrange) or lower than ‘-1999’ (underrange).
Select ‘ FLSH ’ to enter reading into flash mode. Select ‘ to_0 ’ to apply
a reset to ‘0’. Select ‘ to_P ’ to apply a reset to preset value.
1.19.22 Brightness
1.19.17 Left zeros
The ‘ Left zeros ’ (‘ L.ZEr ’) parameter controls the left zeros on or off.
1.19 Configuration menu (cont.)
Counter
overrange
Flash
To zero
To preset
Counter
underrange
Flash
To zero
To preset
Left zeros
With left zeros
Without left zeros
Password
Version
Factory reset
Minimum
Brightness
Maximum
Standard
Vexc. control
with Vexc. error control
without Vexc. error control
1.19.23 Access to optional modules
The ‘ Vexc control ’ (‘ V.ctr ’) parameters enables the ‘Err.8’ message,
when consumption requested to the excitation voltage is higher than
the current the instrument can provide.
Option 1
Configuration menu for the module installed at Opt.1
Option 2
Configuration menu for the module installed at Opt.2
Option 3
Configuration menu for the module installed at Opt.3