Felston DD540, Руководство пользователя, Страница: 10 / 16

Connections
Connect the digital audio output from the source(s) to the In A
and/or In B sockets of the DD540 using optical or coaxial cable
as required. If you are using coaxial cable, take care to connect
to the
digital audio output socket of the source – it may be
labeled “digital audio”, “SPDIF”, “coax audio” or similar, and
should have either an orange- or black-colored insert in its
socket.
Connect the AV amplifier’s digital audio input socket to either
the Out A or Out B socket of the DD540.
Unit Settings
When power is applied to the DD540, the output
configuration is indicated briefly on the display,
either
CF1 or CF2 . Check that CF2 is displayed. If
not, change the setting to CF2 as described in
section Menu Options on page 13.
Power
Whichever output configuration is used, when the connections to
the Digital Audio In and Digital Audio Out sockets are complete,
plug the power adaptor’s connector into the power socket of the
DD540. Finally plug the power adaptor into a wall socket.
When power is connected to the DD540, the display will briefly
show
CF1 or CF2 to indicate that the unit is set for output
configuration 1 or 2. After a couple of seconds, the DD540 will
enter standby mode.
10