Felo FW-06, Руководство по обслуживанию

Страница: 34 / 134

Spot Inspection and Adjustment
30 Service Manual
■
Adjust the drive belt tension
1. Perform the following spot inspection:
a. Point the sonic belt tension tester sensor at the
belt.
b. Gently tap the belt with a screwdriver or a small
metal rod.
c. Measure the vibration frequency of the belt.
When its vibration frequency exceeds the
specified range, promptly adjust it .
Belt curvature: 55-65 Hz
2. Perform the following spot inspection:
a. Support the motorcycle at the side stand on a
flat, hard surface.
b. Loosen the nut
1
at the rear end of the rocker
arm.
c. Loosen the adjusting bolt
2
and
3
of the drive
belt.
d. Adjust the belt tension through adjusting
2
and
3
until the specified value is reached.
e. Tighten and lock the adjusting nut
1
until the
specified torque is reached.
f. Tighten the nut
1
at the rear end of the lower
rocker arm until the specified torque is reached.
Nut at the rear end of the rear rocker arm: 35 N·m
■
Motorcycle fastening
Check if all the nuts, bolts and screws of the
motorcycle have been fully tightened according to the
specified torque factors.
For more information, please see Page 8.
1
2
3