THERMAL RE-SET
The machine is supplied with a thermal re-set switch. The switch will activate
when the machine becomes too hot. This condition should not occur during
normal use. To re-set the switch:
• Isolate the machine from the mains supply.
• Safely support the machine - to access the underside.
• Using a cross-head screwdriver, open the cover plate.
• Using a suitable tool, insert the tool through the aperture and press the
metal switch until it snaps closed. The switch will close correctly, only if the
machine is cool enough.
• Replace the cover plate and screws.
• Power-on the machine.
TROUBLESHOOTING
Problem
Possible cause
Solution
No power on LED
Machine is not switched on
Switch on machine at rear next to plug inlet and at the wall socket
Ready light does not come on after a
long period
Machine is in a hot or humid area
Move the machine to a cooler and dry area
Pouch does not completely seal the item
Item may be too thick to laminate
Pass through the machine again
Temperature setting may be incorrect
Check pouch thickness is correctly selected and pass through again
Pouch has waves or bubbles
Temperature setting may be incorrect
Check pouch thickness is correctly selected and pass through again
Pouch is lost in the machine
Pouch is jammed
Select reverse button and pull out the item by hand. Check cooling
plate is correctly positioned.
Jamming
Pouch was used ‘open end’ first
Pouch was not centred on entry
Pouch was not straight upon entry
Empty pouch was used
Cooling plate not fixed correctly
Pouch is damaged after lamination
Damaged rollers or adhesive on rollers
Pass cleaning sheets through the machine to test and clean rollers
Temperature not increasing
Main fuse failure
Check and replace
Power cord not fitted correctly
Curled or burnt laminations
Too hot
Reduce temperature or increase speed
Soft or poor lamination
Too cold
Increase temperature or reduce speed
Rollers not running
Rollers too cold (< 60°c)
Wait for rollers to warm-up
"STOP" button may be pressed
Press "MOTOR" or "SPEED" button
Unstable lamination temperature
Roller electric brush may be broken
Contact service engineer
Cannot select any Mode
Circuit board error
Rollers not running & motor is running
Loose circuit bolts on gear
Excessive noise
Gears word or damaged
Master fuse keeps failing
Damaged circuit board
7
405600_EUR_Proteus_All_v1.5.indd 7
12/23/2010 1:50:33 PM
