Felker FRS-30, Инструкция по эксплуатации и перечень запасных частей

Страница: 17 / 64

17
• On Models
FRS-30 and FRS-38
you must pull the
handle G (Fig. 10) downwards to set depth of cut and
lock in position by tightening Knob H (Fig. 10).
• Carefully pull handle F (Fig. 10) & G (Fig. 10) to ad-
vance the cutting blade through the material.
• Make the cuts from left to right with the material with
the material up against the backstop on the far right
of the table.
• To tilt the head J (Fig.11) 0°- 45°, loosen the two
side lever handles K (Fig. 11). Adjust to the angle
needed and tighten the lever handles again.
NOTE:
To accurately set 0° tilt, adjust the micrometric screws
L (Fig. 11).
Fig.10
G
H
Fig.11
J
K
L
K