Page | 45
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
[email protected]
Position
Extruder
Fan speed
SD card
Debugging
Configuration
Back
General
Language
Acceleration
Feedrate
Extruder
Configuration
Stored in EEPROM
Back
Select extr. 1
Select extr. 2
X-Offset: 16.00
Y-Offset: 0.00
Steps/MM: 147.0
Acceleration
Feedrate
Extruder
Heating Bed
Store to EEPROM
Load f. EEPROM
In main menu scroll down to
configuration.
Scroll down to extruder
Scroll down and make sure extruder
2 is selected.
Then set the new x and y offsets.
The new x offset 16 + 0.2 = 16.2mm
Then new y offset is 0 - 0.3 = -0.3mm
After changing values, go Back one menu
It will show the message above. Click
the rotary button to dismiss this
message. And go all the way back to the
main menu.
Please print the 02_... file again to check
if calibration values have the correct
results. If this is not the case, please
repeat this process.
Store the changed values to memory.
If you don’t do this, values will be lost
after turning off power.
Back
Select extr. 1
Select extr. 2
X-Offset: 16.20
Y-Offset: -0.30
Steps/MM: 147.0
