20
!
Dust Extractor
RL 250/RL 300
Vacuum hose port/casing/Electrical connection
10 Vacuum hose port/casing
If connecting a vacuum hose, only use electrical conduc-
tive and flame-resistant hoses. Ensure that the electrical
connection between the hose and the pipe connector is
free of defects.
If a so-called „coil hose“ is used, the metal coil must be
stripped and the hose pressed onto the wall of the con-
nector with a pipe wall clamp or a ring-tightener. Plastic
hoses must be flame-resistant.
Only use sheet metal pipes to connect to a pipe (pipe-
work). Use optimised flow lateral pipes and elbows (no
T-branches and/or 90° elbow fittings). The pipe fittings
have to be connected together hermetically and must
conduct electricity.
Use a sluice gate if the sum of the connected cross-sec-
tions is larger than the cross-section of the extraction
opening of the dust extractor.
We recommend the use of a qualified professional to
design and lay the pipework.
11 Electrical connection
Check if the power-supply indicated on the factory name
plate corresponds with the mains before connecting the
device to the mains supply available.
This device may only be operated if the mains has an
earthed neutral conductor!
Attention! Note the direction of rotation!
Check that the direction of rotation is correct before
starting the machine. The direction of rotation can be
determined by switching the motor on and off, by obser-
ving the cooling fan on the motor and comparing it to
the direction of rotation arrow.
If the direction of rotation is incorrect, change the polari-
ty. Change the polarity with the phase reverser built into
the plug. The direction of rotation of the ventilating fan is
changed by turning the pole pin built into the insulated
part of the plug with a screwdriver.
Attention! If the direction of rotation of the drive motor is incorrect, for example as a result of the incorrect
polarity, switch the machine off immediately, as the resulting suction output is not sufficient, and it prevents
the machine from heating up (prohibited).
Connect the converter coils in the connecting lead of
the appropriate woodworking machine as depicted in
the wiring diagram „Converter inputs“ in the annexed
Control operating manual.
This task may only be carried out by qualified profession-
als.
Содержание RL 250
Страница 33: ...33 Dust Extractor RL 250 RL 300...
Страница 34: ...34 Dust Extractor RL 250 RL 300...
Страница 35: ...35 Absaugger t RL 250 RL 300 Dust Extractor RL 250 RL 300...
