OBID i-scan
®
System-Manual
ID ISC.LR200
FEIG ELECTRONIC GmbH
Page 93 of 174
H90692-16e-ID-B.doc
DB:
Data of the data block to be written to the Transponder. The required block size is defined by
DB-SIZE. The number of the expected bytes are DB-N * DB-SIZE.
ISO-ERROR:
(only ISO15693 Transponders)
ISO15693 error code of Transponder response. This byte is only available if STATUS = 0x95.
DB-ADR-E:
Block number where the error occurred.
Notes:
•
A write to 1 block uses a Write Single Block command to the Transponder. This will be
managed by the Reader internally.
•
If a Transponder does not support Write Multiple Blocks commands several Write Single
Block commands are used for this Transponder.
•
A write command on I-Code 1 Transponders can only be performed in the addressed mode.
•
A write command on EPC Transponders can only be performed in the non-addressed mode
whereas the block-size (DB-SIZE) must be 1 Byte.
•
If an EPC Transponder is already locked, the reader answers with status = [0x03].
•
The write function onto an I-Code EPC takes about 100ms per byte.
•
A write command on Tag-it HF Transponders cannot be performed in the selected mode.