OBID i-scan
®
Application Note
ID ISC.ANT1400/760-C/B
FEIG ELECTRONIC GmbH
Page 29 of 31
N70100-0de-ID-B.doc
E N G L I S H
2.3.5 Tuning the Gate Antenna
Before tuning the gate antenna, you must quit the ISOStart software. Then the gate can be tuned
as follows:
Step
Action
Note
1
Start “DATuningTool” software
2
Select “Detect Reader...”.
In the „Detect Reader“ window
select the interface (COM-Port
1, BusAdr. 0) and then press
“Detect”.
3
Use „Settings“ to enter the
configuration:
Single Mode,
Number of Antennas 3 to 5
Click on “with Multiplexer“
Number of Tuning Iterations 3
4
Activate „Start Tuning“ and
wait until the tuning process is
finished.
...
...
5
The tuning status is displayed
after each tuning process.
After successful tuning both
antennas are shown in green.
A red marked antenna shows
a not successful tuning.
6
If this does not succeed on
the first try, start the process
over again by clicking on
„Start Tuning“
After successful tuning, close the DATuningTool.
3 to 5
