Feig Electronic ID ISC.LRU1002-FCC, Руководство по установке

Страница: 19 / 29

OBID i- scan
®
UHF Installation ID ISC.LRU1002
FEIG ELECTRONIC GmbH Page 19 of 29 M31010-1e-ID-B.docx
5. Operating and Display Elements
5.1. Status LEDs
Table 13: Configuration of the LEDs
Green Yellow Red Description
ON OFF ON Boot sequence (ca.10s) after power on
FLASH OFF
OFF Normal Reader operation (without Host communication)
FLASH FLASH OFF Reader receives a valid protocol from host
FLASH OFF ON RF Warning [0x84] (without host communication)
FLASH
(alternat-
ing)
OFF
FLASH
(alternat-
ing)
Firmware Activation necessary [0x17] /
Wrong Firmware [0x18]
FLASH
(synchro-
nous)
OFF
FLASH
(synchro-
nous)
RFC Hardware Error [0xF1]
OFF
FLASH
(synchro-
nous)
FLASH
(synchro-
nous)
Hardware Warning
(EEPROM Error / RFC not detected)
Firmware Update:
FLASH FLASH FLASH Firmware transfer from host to reader
(Please do not switch off the reader or disconnect the interface cable)
(light in sequence)
Configurations-Reset:
FLASH FLASH FLASH
While T1 is pushed and hold for maximal 5s
(light in sequence)
ON ON ON
After T1 has been pushed and hold for 5s. Configuration
Reset has been finished.
ANT 1- 4
RUN
Host
Communication
Warning
RFU