and operated as normal.
♦ If motor has cooled, button will remain in.
6.4 MATERIAL REMOVAL DEPTH SCALE (FIG. L)
Your planer is equipped with a material removal gauge (8). It is used to indicate the amount of wood that
will be removed in one pass with the carriage set at its current height.
TO USE THE MATERIAL REMOVAL DEPTH SCALE
♦ WARNING: During the initial cutting for the new tool, it is recommended that the first cut depth adjustment
shall be less than 1.5mm.
♦ Be sure the wood is lying flat against the base of the planer. If the material is inserted at an angle, the
reading may be inaccurate.
♦ Crank the carriage down on the material until the material removal bar engages the wood. You will see
the red arrow begin to move up the scale indicating the amount of material to be removed with the
carriage at that height.
♦ Adjust the carriage height until the desired depth of cut appears on the scale.
♦ Pull the material out from under the carriage.
♦ Turn the unit on and feed your material into the cutterhead.
6.5 ANTI-KICKBACK DEVICE (FIG.Z)
14
