Board thickness does
not match depth scale
indicator.
Depth scale incorrectly set.
Adjust depth scale.
Dirty planning table.
Clean and wax planning table.
Cutter head height difficult
to adjust.
Dirty elevation spindle.
Clean and lubricate spindle.
Worn chain.
Have service performed by an authorized
service center.
Will not start.
Not plugged in.
Check power source.
Blown circuit.
Replace fuse, reset breaker, or call
electrician.
Motor failure.
Have service performed by an authorized
service center.
Loose wire.
Have service performed by an authorized
service center.
ON/OFF switch malfunction.
Have service performed by an authorized
service center.
Motor is overloaded.
Push reset button.
Interrupted operation.
Unit overloaded.
Reduce load.
Circuit overloaded.
Operate on circuit separate from other
appliances or motors or connect to circuit
with adequate amp rating.
Cutter head will not
lower to plane
material.
Turret stop setting too high.
Lower turret stop setting.
9. DISPOSAL
Electrical products should not be discarded with household products. According to the European Directive
2012/19/EU on waste electrical and electronic equipment and its implementation into national law, electrical
products used must be collected separately and disposed of at collection points provided for
this purpose. Talk with your local authorities or dealer for advice on recycling.
22
