start-up can cause injury.
4.5 TABLE EXTENSIONS (FIG. D)
Before using your planer, fold down the table extensions in the front and back of the tool. After extended
use, the table extensions may be slightly out of level.
NOTE: The outside edges of the extension tables are level with the base while the inside edges (closest to
the cutterhead) are below the edge of the base. This is set at the factory to reduce unnecessary friction
between the material and the table while providing adequate support at the two points (those farthest from
the cutterhead) on the tables that are integral to snipe prevention.
4.6 INSTALLING THE DUST CHUTE (FIG. E-H)
1) Loosen Screws
♦ Using the hex wrench (included), loosen the two marked screws (24) located at the rear of the cutter
head assembly and do not remove them.
2) Align Notches with Screws
♦ Align the two notches (25) on the dust chute (18) to the two loosened screws (24).
3) Align Slots with Hooks
♦ Align the two slots (26) with the two hooks (27) on the machine. If the dust chute is a little deformed, it
may be necessary to use some pressure to ensure that the slots and hooks match properly.
10
