ASSEMBLY
Check for damage to the tool, parts and accessories which may have occurred during
transportation. Take some time to read this manual carefully and understand all the content
prior to assembly and operation.
CAUTION!
Always ensure that the tool is switched off and unplugged from the mains supply
before assembly.
Changing the Blade
1. Place the saw on a side of a flat surface.
2. Rotate the saw blade by hand while depressing the Spindle Lock Button until the blade is
locked; Turn the blade clamp screw use the wrench provided in anti-clockwise direction.
3. Remove the blade clamp screw, outer flange, and washer.
4. Lift the lower guard by using the lower guard lever and remove the blade.
5. Clean the saw blade flanges, and then mount the new saw blade onto the spindle, which
is against the inner flange.
1.
Make sure the saw teeth and arrow on the blade is to the same direction as the arrow
on the lower guard.
2.
Reinstall the outer flange, washer and tighten the blade clamp screw.
3.
Make sure the saw blade can run freely by turning the blade by hand.
Parallel cut adjustment
1.
Loosen the edge guide locking screw
.
2. Slide the edge guide through the slots in the shoe to the desired width.
3. Tighten the lock screw to secure it in the position.
4. Ensure that the edge guide rests against the wood along it entire length to give a
consistent parallel cuts.
OPERATION
Switching on and off
Note:
Before engaging the on/off switch, check the saw blade to see if it is fitted properly and
runs smoothly, and the blade clamp screw is well tightened.
1.
Connect the plug to the power supply.
2.
To start the tool, depress the lock-off button and pull the switch trigger.
11
