GB
14
Figure 1
2
、
Step 7: Use the wooden hammer to knock the 17 pieces of
fixed
⑦
gently into the
installation hole of the protection guard
②
and the back cover
③
, and then gently knocked the
fixed
⑦
into the installation hole of the right and left cover. See figure 2
Figure 2
3
、
Complete the above steps, one complete machine assembly is completed
4
、
If you choose a machine without extra legs, please place the machine safely on the
workbench surface 850mm above the ground before using.
OPERATION
Warning!
Before operating the log splitter, the Bleed Screw (15) Fig. 6, should be
loosened by some rotations until air can go in and out of the oil tank
smoothly.
Air flow through the Bleed Screw hole should be detectable while the log
splitter is under operations.
Before moving the log splitter, make sure the Bleed Screw is tightened to
avoid oil leaking from this point.
Failed to loosen the bleed screw will keep the sealed air in hydraulic system being
compressed after being decompressed, such continuous air compression and
decompression will blow out the seals of the hydraulic system and cause
permanent damage to the log splitter.
